Filter
Top Products
9
Use a straight edge (C) Fig. 6 to be sure that the
extension wing (A) and the saw table (D) are even with
each other before tightening the screws (B) Fig. 5.
C
A
D
If your saw has magnetic push button electrical controls,
the starter box is already wired to the switch and motor.
However, you will need to mount the starter box to the
saw cabinet.
1. Place a 1/4" lockwasher, then a 1/4" flat washer on
a 1/4-20x1/2" hex head bolt. Insert the bolt through
one of the holes (B) Fig. 7 on the inside of the saw
cabinet and into the matching tapped hole (C) Fig. 7
in the starter.Tighten just enough to hold the starter.
2. Repeat for the remaining 2 holes.
3. Tighten all three bolts securely.
ATTACHING THE LVC STARTER BOX TO THE CABINET
1. Locate the LVC switch (A) Fig. 8 and the hardware that was removed in the section “ATTACHING THE EXTENSION
WING.”
2. Use the hardware to mount the switch bracket (C) Fig. 9 to the inside of the table through the hole (D) on the left
front edge of the extension wing.
NOTE: If you have a GPE switch see “ATTACHING THE GPE ON/OFF Switch” instructions.
ATTACHING THE LVC ON/OFF SWITCH
Fig. 6
Fig. 7
A
B
C
Fig. 8
Fig. 9
A
D
c
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:42 PM Page 9