Filter
Top Products
12
8. Use a 5/16-18x1" hex head bolt (N) with 5/16"
lockwasher and 5/16" flat washer to attach the upper
splitter bracket (M) Fig. 20 to the lower bracket (L) .
NOTE: Hand tighten only.
9. Insert the front end of splitter (P) Fig. 21, inside the
splitter mounting bracket, behind the splitter fastener
plate and the screw (C). Push the splitter down as far
as possible, making certain that the bottom edge of
splitter (P) is parallel with the table surface. Tighten
the screw (C). Fasten splitter and blade guard
assembly (P) Fig. 22 to the bracket (M) using a 5/16-
18x1" hex head bolt (V) and 5/16" flat washer.
IMPORTANT: The splitter (P) Fig. 23, features a notch (W)
cut into the top edge. Raise the front of the clear blade
guard (P) Fig. 23, until the rear edge of the guard slips into
notch (W) of the splitter. This notch enables the blade
guard to stay in the raised position and makes changing
blades easier.
11. Install the saw blade, making certain the teeth are
pointing down at the front of the saw table (Fig. 24).
Install the outside blade flange and arbor nut (X). With
open-end wrench (Y) on the flats of the arbor to keep
it from turning, tighten arbor nut by turning box-end
wrench (Z) counter-clockwise.
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 25
Fig. 24
M
L
N
C
P
P
M
P
W
Y
X
Z
P
A
B
V
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 12