Filter
Top Products
12
11. Reassemble the saw blade, making certain the teeth
are pointing down at the front of the saw table as shown
in Fig. 23, and assemble the outside blade flange and
arbor nut (X). With open end wrench (Y) on the flats of the
arbor to keep it from turning, tighten arbor nut by turning
box end wrench (Z) counterclockwise.
12. Using a straight edge (A) Fig. 24, make certain the
splitter (P) is aligned with the saw blade (B). Using a
square (C) Figs. 25 and 26, make certain saw blade (B)
Fig. 25, and splitter (P) Fig. 26, are 90 degrees to the table
surface. Once you are certain the splitter is aligned to the
saw blade and table, tighten all splitter mounting
hardware (D) Fig. 26 and recheck alignment.
13. Holding the clear blade guard, lower the saw blade
and assemble the table insert (E) Fig. 27, into the opening
on the saw table.
Fig. 23 Fig. 24
A
P
B
X
Z
Y
Fig. 25
Fig. 26
Fig. 27
E
FASTENING MOTOR CORD
TO SAW FRAME
1. IMPORTANT: Turn the blade tilting handwheel
counterclockwise as far as it will go until the saw blade is
in the 45 degree position.
2. IMPORTANT: Turn the blade raising and lowering
handwheel counterclockwise until the blade is at its
lowest position.
3. Fasten motor cord (A) Fig. 27A to the saw frame
cross member (B), using the cable tie (C) supplied with
the saw. CAUTION: Before tightening the cable tie, make
certain that cord (A) is free of any interference from the
motor or saw blade at all possible positions of the motor.
4. After the cable tie is tightened, cut off excess tail of
cable tie (C) Fig. 27A.
Fig. 27A
C
B
A
B
P
D