Filter
Top Products
14
ASSEMBLY INSTRUCTIONS FOR MODEL 36-918
52" UNIFENCE WITH 34-978 TABLE AND SHELF
1. Fig. 33 shows the hole location for mounting the
Unifence table legs to the table board.
2. Lay the table upside down on the floor or bench, as
shown in Fig. 34.
3. Assemble the two table legs (A) Fig. 35 to the
bottom of the table using eight #8x7/8" wood screws.
4. Assemble shelf support bracket (B) Fig. 36, to the
table legs (A) using two U-clamps (C), flat washers, and
hex nuts. NOTE: The shelf support bracket should be
attached to the legs with the shelf support bracket
facing the long end of the table board. NOTE: Height
adjustments to the bracket will be made later.
5. Insert foot adapter (T) Fig. 37, into the bottom of
each leg (A). Assemble the 3/8" jam nut (V)
approximately 3/4 of the way onto leveling screw (W).
Thread the leveling screw (W) into foot adapter. Fig. 38
illustrates the foot leveling assembly on the table leg.
Assemble the remaining foot assembly to the other table
leg in the same manner. NOTE: Height adjustments can
be made later.
Fig. 33
Fig. 34
Fig. 35
Fig. 36
A
A
B
A
C
Fig. 37
Fig. 38