Filter
Top Products
18
8. Move the square (H) Fig. 54, to the end of the
Unifence table and check to make certain the same
distance is maintained from the top surface of the
extension table (K) to the top surface of the guide rail (C).
Move the front table support (L) Fig. 55, against the guide
rail (C), and tighten the 1/4-20 nuts (M). Tighten two wood
screws, one of which is shown at (N) Fig. 55, that fasten
the Unifence table to the guide rail.
Fig. 55
M
M
L
C
N
ASSEMBLING UNIFENCE
RAIL STOP
1. Insert 1/4-20x2" bolt (A) through hole into one side of
bracket (B) Fig. 56.
2. Place one washer (C), on bolt (A), and slide bolt
through flip stop (D) Fig. 56.
3. Place the other washer (C), on bolt (A), and slide bolt
(A) through other side of bracket (B) Fig. 56.
4. Screw the lock nut (E) onto bolt (A) and tighten until
the flip stop will stay up.
5. Insert bolt (F) through bracket (B) as shown and
screw knob (G) onto bolt (F) approximately 3 complete
turns. Fig. 56.
6. To attach rail stop to unifence as shown in Fig. 58.
7. Using a rubber mallet (P) Fig. 57, or a hammer and a
block of wood, gently tap end cap (R) into both ends of
the guide rail. NOTE: To avoid damage to the guide rail,
DO NOT use a metal hammer directly against the guide
rail.
Fig. 56
E
C
F
B
A
G
D
Fig. 57
Fig. 58
P
R
F
G
Fig. 59
SETTING FLIP STOP
1. The Flip Stop Assembly Fig. 58, can be set to any
number of positions along the guide rail providing a
quick stop setting for the Unifence body by loosening
knob (G) and sliding the stop along the rail to the desired
position and re- tighten.
2. Any number of stops can be purchased and installed
to provide time saving quick stop setting for the Unifence
body.
3. If flip stop does not retract fully the bolt (F) Fig. 58,
may have to be repositioned in the rail slot to allow the
flip stop to retract fully. If bolt (F) needs to be
repositioned, just slide the bolt out of the rail and turn the
head of the bolt one third of a turn (one flat) and slide
back into rail, repeat this until the bolt is in the right
position for the flip stop to retract fully. Fig. 59.