Filter
Top Products
v
Using Your Tester Safely
Warning
To avoid electric shock, use only the test leads supplied
with the Tester. Use 600V rated probe tip adapters.
(“600V” is printed on the equipment.) Remove all test
leads that are not in use.
Use only the 80i-500s ac current probe or a safety-
designed equivalent (such as the Fluke Model 80i-1000s)
that is rated for 600V on both the jaws and the measuring
secondary. Remove any current probe that is not in use.
In this manual, a WARNING identifies conditions and actions that pose haz-
ard(s) to the user. A Caution identifies conditions and actions that may dam-
age the tester or the current probe. See below for explanations of international
electrical symbols.
Read the following safety information carefully before attempting to operate
or service the Tester or the current probe.
DANGEROUS VOLTAGE
AC-ALTERNATING CURRENT
DC-DIRECT CURRENT
Either DC or AC
CAUTION see explanation in
manual
Equipment protected throughout
by DOUBLE INSULATION or
REINFORCED INSULATION
EARTH
HIGH BNC INPUT
RECYCLING
International Safety Symbols
Safety Guidelines for Tester and Voltage Probe
To ensure that you use your Tester safely, follow these guidelines:
• Avoid working alone.
• Inspect the test leads for damaged insulation or exposed metal. Check test
lead continuity with a multimeter. Replace damaged leads.
• Do not use the Tester if it looks damaged.