Filter
Top Products
-8-
G0456 Variable Speed Wood Lathe
Additional Safety for Wood Lathes
9. WORKPIECE CONDITION. Always inspect
the condition
of your workpiece. DO NOT
turn pieces with knots, splits, and other
potentially dangerous conditions. Make
sure joints of glued-up pieces have high
quality bonds and won't fly apart during
operation.
10. ADJUSTMENTS/MAINTENANCE. Make
sure your wood lathe is turned
OFF, dis-
connected from its power source, and all
moving parts have come to a complete
stop before starting any inspection, adjust
-
ment, or maintenance procedure.
11. STOPPING LATHE. DO NOT stop the lathe
by using your hand against the workpiece.
Allow the lathe to stop on its own.
12. AVOIDING ENTANGLEMENT. Keep long
hair and loose clothing articles such as
sleeves, belts, and jewelry items away
from the lathe spindle.
13. FACEPLATE TURNING. When faceplate
turning, use lathe chisels on the downward
spinning side of the workpiece only.
14. SANDING/POLISHING. Remove the tool
rest when performing sanding or polishing
operations on the rotating spindle.
15. MATERIAL REMOVAL RATE. Attempting
to remove too much material at once may
cause workpiece to fly out of the lathe.
1. KEEPING GUARDS IN PLACE. Make
sure all guards are in place and that the
lathe sits on a flat, stable surface.
2. EYE/FACE PROTECTION. Always wear
eye protection or a face shield when oper
-
ating the lathe.
3. RESPIRATORY PROTECTION. Always
wear a respirator when using this machine.
Wood dust may cause allergies or long-
term respiratory health problems.
4. MOUNTING WORKPIECE. Before start-
ing, be certain the workpiece has been
properly imbedded on the headstock and
tailstock centers and that there is adequate
clearance for the full rotation.
5. ADJUSTING TOOL REST. Adjust tool rest
to provide proper support for the turning
tool you will be using. Test tool rest clear
-
ance by rotating workpiece by hand before
turning lathe
ON.
6. TURNING SPEED. Select the correct turn-
ing speed for your work, and allow the lathe
to gain full speed before using.
7. USING SHARP CHISELS. Keep lathe
chisels properly sharpened and held firmly
in position when turning.
8. OPERATING DAMAGED LATHE. Never
operate the lathe with damaged or worn
parts.
No list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Like all machinery there is potential danger
when operating this machine. Accidents are
frequently caused by lack of familiarity or
failure to pay attention. Use this machine
with respect and caution to lessen the pos
-
sibility of operator injury. If normal safety
precautions are overlooked or ignored, seri
-
ous personal injury may occur.