Filter
Top Products
-14-
G0456 Variable Speed Wood Lathe
Sanding Table
Components and Hardware Needed: Qty
Sanding Table ....................................................
1
Table Brackets ...................................................
2
Dust Port ...........................................................
1
Lock Handles ...................................................
2
Flat Washers
1
⁄4" (Handles) ............................... 4
Cap Screws
5
⁄16"-18 x
5
⁄8" (Table) ....................... 2
Lock Nuts
5
⁄16"-18 (Table) ................................... 2
Flat Washers
5
⁄16" (Table) .................................. 2
Phillips Head Screws 10-24 x
1
⁄2" (Dust Port) ... 2
Lock Washers #10 (Dust Port) ..........................
2
To install the sanding table:
1. Mount the dust port to the casting with the
Phillips screws and lock washers.
2. Mount the table to the casting with the cap
screws, flat washers, and lock nuts through
the hinge hole; and with the lock handles
and lock washers through the slotted hole.
Figure 7 shows the table properly installed.
Figure 7. Table and dust port properly installed.
Tool Rest
Components and Hardware Needed: Qty
Tool Rest ...........................................................
1
To install the tool rest:
1. Slide the tool rest shaft into the base, and
tighten the lock handle. Figure
8 shows the
tool rest properly installed in the base.
Figure 8. Tool rest properly installed.
Lock Handle