Filter
Top Products
G0456 Variable Speed Wood Lathe
-17-
The tailstock is equipped with a cam-action
clamping system to secure it to the lathe bed.
When the lever is tightened, a locking plate lifts
up and secures the tool rest to the bed.
To position the tailstock along the bed:
1. Loosen the quick release and move the
tailstock to the desired position (
Figure 12).
2. Tighten the quick release.
—If the quick release will not lock the tailstock
down onto the bed (either too loose or
too tight), loosen or tighten the hex nut
(located on the underside of the tailstock)
in small increments as needed to achieve
the proper clamping pressure.
Figure 12. Tailstock controls.
Adjusting Tailstock
Quick Release
The tool rest is equipped with a cam-action
clamping system to secure it to the lathe bed.
When the lever is tightened, a locking plate lifts
up and secures the tool rest to the bed.
To position the tool rest along the bed
:
1. Loosen the base lock and move the tool rest
to the desired position (
Figure 13).
Figure 13. Tool rest controls.
Adjusting Tool Rest
Base Lock
2. Tighten the base lock.
— If the base lock will not lock the tool rest
down onto the bed (either too loose or too
tight), loosen or tighten the hex nut (located
on the underside of the tool rest) in small
increments as needed to achieve the prop
-
er clamping pressure.
3. Use the tool rest lock to adjust the tool
rest height as needed.
Figure 25 on Page
22 shows how to find the proper tool rest
height.
Tool Rest
Lock