Filter
Top Products
-18-
Model G0563/G0564 (Mfd. Since 10/11)
Back Stop
Components and Hardware Needed: Qty
Hex Bolts
5
⁄16"-18 x 1" ......................................... 2
Flat Washers
5
/16" ............................................... 2
Back Stop .......................................................... 1
Tools Needed:
Open-End Wrench 10 x 12mm .......................... 1
To mount back stop:
1. Place a washer on each hex bolt and thread
approximately one turn into holes in platen,
as shown in Figure 5.
Figure 5. Back stop bolts.
2. Slide back stop onto hex bolts and tighten,
allowing
1
/8" clearance from belt to bottom of
the back stop, as shown in Figure 6.
Figure 6. Back stop installed.
Dust Port Cover
Components and Hardware Needed: Qty
Dust Port Cover ................................................. 1
Hinge Pins ......................................................... 2
Tools Needed:
Hammer ............................................................. 1
To mount dust port cover:
1. Align dust port cover hinges with hinges on
back of sander.
2. Insert hinge pins through aligned hinges, as
shown in Figure 7, and tap with a hammer for
full insertion.
Figure 7. Dust port cover installed.
Hinge Pins
Dust Port Cover
3. Latch belt access door to dust port cover.