Filter
Top Products
Model G0563/G0564 (Mfd. Since 10/11)
-35-
Figure 35. Angle indicator pin screw.
Removing Drive
Roller
The Model G0563/G0564 comes equipped with a
puller to remove the drive roller should it become
necessary to do so.
Tools Needed:
Cap Screw
5
⁄16"-18 x 1
1
⁄4" .................................... 1
Cap Screw
1
⁄4"-20 x 1
3
⁄4" .................................... 2
Drive Puller Plate ............................................... 1
Hex Wrench 5mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Socket
7
/8" .......................................................... 1
Ratchet w/6" extension ...................................... 1
6. Align angle indicator pin with the 90˚ mark
and tighten angle indicator pin screw.
Figure 36. Using the drive roller puller.
4. To re-install, place drive roller on shaft, and
thread the lock washer and hex nut onto shaft
and tighten securely.
NOTE—Do not hammer drive roller onto
shaft or you will cause damage to the shaft.
5. Loosen angle indicator pin screw, shown in
Figure 35,
1
⁄2 turn.
To remove drive roller:
1. Remove hex nut and lock washer securing
driver roller to shaft.
2. Thread the two
1
⁄4"-20 x 1
3
⁄4" cap screws on
the puller four turns into the threaded holes in
drive roller.
3. Thread and tighten the
5
⁄16"-18 x 1
1
⁄4" cap
screw on the puller, shown in Figure 36, until
drive roller is pulled.