Filter
Top Products
-20-
Model G0563/G0564 (Mfd. Since 10/11)
Te st Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON. Verify motor operation,
and then turn machine OFF. The motor
should run smoothly and without unusual
problems or noises.
Figure 11. Emergency stop button.
4. Turn machine ON. Press Emergency Stop
Button, shown in Figure 11.
—If the machine stops, the EMERGENCY
STOP button is working properly.
Congratulations! The Test Run is complete.
—If the machine does not stop, immediately
disconnect power to the machine. The
EMERGENCY STOP button is not work-
ing properly. This safety feature must work
correctly before proceeding with regular
operations. Call Tech Support for help.