Filter
Top Products
Model G0563/G0564 (Mfd. Since 10/11)
-29-
SECTION 6: MAINTENANCE
Lubrication
After operating the Model G0563/G0564 for
approximately 500 hours, refill the gearbox with
oil.
Tools Needed:
Wrench 10 x 12mm Open-End .......................... 1
Hex Wrench 5mm .............................................. 1
Grease Gun w/All Purpose Grease ................... 1
Oil Can w/Light Machine Oil .............................. 1
SAE 80W Gear Oil ............................................ 1
To check and refill gearbox:
1. Place belt sander in the horizontal position.
2. Remove the cap screws on top of the gear-
box cover shown in Figure 28.
Figure 28. Gearbox cap screws.
3. Remove the hex bolts on opposite side of
gearbox and remove the gearbox cover.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury
General
Regular periodic maintenance of your Model
G0563/G0564 will ensure optimum performance.
Make a habit of inspecting your machine each
time you use it. Check for the following conditions
and repair or replace when necessary:
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged or worn sanding belt.
5. Any other condition that could hamper the
safe operation of this machine.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Always disconnect power
to the machine before per-
forming service adjust-
ments. Failure to do this
may result in serious per-
sonal injury.