Filter
Top Products
-34-
Model G0563/G0564 (Mfd. Since 10/11)
This section is designed to help the operator with
adjustments that were made at the factory and
that may also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform any
procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
About Service
Calibrating Angle
Gauge
In order to maintain accuracy and precision with
the oscillating edge sander, periodically calibrate
the angle gauge.
Tools Needed:
Machinist's Square ............................................ 1
Flat Head Screwdriver ....................................... 1
To calibrate angle gauge:
1. Loosen angle adjustment lock handle.
2. Place machinist's square on table and press
it against the platen.
3. Adjust platen until it is flush with the
machinist's square, as shown in Figure 34.
Figure 34. Aligning table to platen.
4. Tighten angle adjustment lock handle.
Always disconnect power
to the machine before per-
forming service adjust-
ments. Failure to do this
may result in serious per-
sonal injury.