Filter
Top Products
Model G0563/G0564 (Mfd. Since 10/11)
-23-
Table Adjustment
The table on the oscillating edge sander moves
both vertically and horizontally to accommo-
date various workpieces shapes and thicknesses.
Adjust table height periodically to reduce spot
wear of your sanding belt.
To vertically adjust table:
1. Loosen the lock handles that secure table
height position.
2. Turn table height adjustment wheel shown in
Figure 16, clockwise to raise table or coun-
terclockwise to lower table.
Figure 16. Height adjustment controls.
3. When desired position is achieved, tighten
the lock handles to secure table height.
Handwheel
Lock
Handles
Platen Angle
Adjustment
The sanding angle of the oscillating edge sander
is variable between 0 and 90 degrees.
To adjust platen angle:
1. Loosen angle adjustment lock handle and
tilt sander until the pointer is aligned with
desired angle, as shown in Figure 15.
Figure 15. Adjusted sanding angle.
2. Tighten angle adjustment lock handle.
N o t e — Refer to Page 32 to calibrate angle scale.
Lock Handle
Pointer
5. Determine if sanding belt is tracking too high,
or too low:
—If belt tracks above center, turn adjustment
nut, shown in Figure 14, counterclockwise.
—If sanding belt tracks below center, turn
adjustment nut clockwise.
6. Tighten jam nut.
7. Connect machine to power and turn ON.
Observe belt tracking behavior:
—If belt is tracking correctly, no further
adjustment is necessary.
—If belt is not tracking correctly, repeat
Steps 3–7.