Filter
Top Products
-26-
Model G0563/G0564 (Mfd. Since 10/11)
Spindle Table Height
The spindle table on the oscillating edge sander
can be moved vertically to accommodate various
sanding operations and to decrease spot wear on
the sanding drums.
Figure 22. Spindle table adjustment lock handle.
KEEP HANDS CLEAR of all
pinch points when adjusting
the spindle table.
To adjust spindle table height:
1. Loosen the adjustment lock handle shown in
Figure 22.
2. Raise or lower spindle table to desired height.
3. Tighten the adjustment lock handle.
Spindle Sanding
The spindle sander on the Model G0563/G0564
produces a high quality sanding finish on inside
contours.
Do not use the spindle sanding attachment
without the spindle table properly installed
and the correct table insert for the drum in
place. Failure to do so could result in seri-
ous personal injury.
Figure 23. Spindle sanding.
4. When you have completed your sanding
operation, turn sander OFF.
To perform spindle sanding operations:
1. Make sure that appropriate spindle and
table insert have been installed correctly
and that both are secured tightly.
2. Position table in desired location and turn
sander ON.
3. While securely holding the workpiece, lightly
press it against the spindle and maintain
consistent pressure against table, as shown
in Figure 23. Use extra caution when sand-
ing end-grain.