Filter
Top Products
-30-
Model G0563/G0564 (Mfd. Since 10/11)
Figure 31. Grease fittings inside sanding body.
Figure 30. Oil ports on oscillating assembly.
Figure 29. Oil fill hole and screw.
5. Re-install gearbox cover with hex bolts and
cap screws.
Rack and Pinion Gear
The rack and pinion gear that moves the table
vertically should be greased well to maintain
smooth operation.
To grease rack and pinion gear:
1. With table in its lowest position, wipe the rack
and pinion with a rag to remove buildup of
sawdust and old grease.
2. Apply a coat of all purpose grease to the rack
and pinion gears.
4. Remove the oil fill plug on top of the gearbox,
as shown in Figure 29 and fill with SAE 80W
gear oil until the level is
1
/2" from the top.
Grease Fittings and Oil Ports
There are two oil ports shown in Figure 30 and
four grease fittings shown in Figure 31. Lubricate
these points after approximately 50 hours of use
with light machine oil.
All other bearings on the Model G0563/G0564 are
sealed and permanently lubricated, so there is no
need to lubricate them.