Filter
Top Products
G0588/G0591 12" Sliding Table Saws
-21-
Sliding Table
The sliding table is a very
heavy unit. Serious per
-
sonal injury may occur
if safe moving methods
are not followed. To be
safe, you will need assis
-
tance and power equip
-
ment when installing the
sliding table.
2. Lift the sliding table onto the table saw as
shown in
Figure 16.
Note: The long bolts go through the circular
holes and the short bolts go into the square
holes.
Figure 16. Installing the sliding table.
Figure 17. Removing cover plates.
3. Remove the cover plates shown in Figure 17
and remove the cover plate under the other
end of the sliding table
.
4. Thread the washers and nuts removed in
Step 1 onto the long bolts.
5. Slide the T-nut into the sliding table and
thread in the handle as shown in
Figure 18.
Table Lock
6. The sliding table is unlocked when the table
lock is in the position shown in
Figure 18.
Rotate the table lock 180˚ to lock the sliding
table.
Figure 18. Sliding table handles.
Handle
DO NOT use the sliding table until it is adjusted
according to the instructions on Page 29
. It will not
produce accurate cuts until properly adjusted
.
Components and Hardware Needed: Qty
Sliding Table .......................................................
1
Push Handle M14-2 x 16 w/T-Nut ......................
1
To install the sliding table:
1. Remove the nuts and washers from the long
bolts. DO NOT remove the nuts and washers
from the shorter bolts.