Filter
Top Products
G0588/G0591 12" Sliding Table Saws
-25-
Main Blade
Components and Hardware Needed: Qty
Blade 12" (Not Included) ....................................
1
Riving Knife ........................................................
1
To install the blade:
1. Move the blade tilt to 0˚ (blade 90˚ to table)
and raise the main blade arbor.
2. Open the cabinet and remove the foam ship-
ping block and the motor support bracket.
3. Slide the table all the way forward to access
the blade arbor, loosen the cap screw secur
-
ing the lower blade guard, slide the cap screw
up, and pull open the lower blade guard (see
Figure 29).
Figure 29. Main blade arbor components.
Main Blade
Arbor
Figure 30. Installing the main blade.
Figure 31. Installing the riving knife.
Riving Knife
4. Place a hex wrench in the hole in the arbor
to prevent the arbor from rotating, then
use
the arbor wrench to remove the arbor nut and
arbor flange.
Note: The arbor nut has left hand threads
and loosens by turning clockwise.
6. Re-install the arbor flange and the arbor nut
and tighten them against the blade as shown
in Figure 30.
7. Loosen the riving knife center bolt, slide the
riving knife between the plates as shown in
Figure 31, and slightly tighten.
5. Slide the blade onto the arbor with the teeth
facing the front of the saw (see
Figure 30).
Note: Wear gloves to protect your hands
when installing or removing blades.
Scoring
Blade Arbor