Filter
Top Products
-44-
G0588/G0591 12" Sliding Table Saws
Lubrication
The bearings are sealed and pre-lubricated and
require no lubrication during their usable life.
However, your saw components will operate
at their best if the bearing surfaces are kept
clean—this is especially important for the trun
-
nion bearings.
Lubricate the areas indicated below every 6-12
months, depending on frequency of use.
1. Blade angling pivots. These should be
lubricated with 6 or 7 drops of light machine
oil (see
Figure 77).
2. Sliding table ways. Spray or wipe on a light
machine oil or lubricant such as Boeshield
T9
®
the entire length of the steel rods (see
Figure 78).
Figure 77. Blade angling trunnions.
3. Blade height worm gears. Lubricate with
an automotive wheel bearing grease (see
Figure 79).
Blade Angling
Trunnion
Figure 78. Sliding table ways.
4. Blade tilt worm gear. Lubricate with an
automotive wheel bearing grease.
Figure 79. Gear lubrication.
Blade Height
Worm Gear
Blade Tilt
Worm Gear