Filter
Top Products
-20-
Model G0755 (Mfg. Since 1/13)
Control Panel
Figure 11. Control panel components.
A
B
C
D
E
F
Refer to Figure 11 and the following descriptions
to become familiar with the control panel func-
tions.
A. Power/ON Lamp Button: Lights when
machine is connected to power. Push this
button to enable power to the motor.
B. Elevation (Z-Axis) Power Feed Switch:
Controls headstock elevation.
C. Spindle Reverse Button: Starts counter-
clockwise spindle rotation.
D. Emergency Stop Button: Cuts power to
spindle and Z-axis motors. This button does
NOT disconnect machine from power.
E. Spindle Stop Button: Stops spindle motor.
F. Spindle Forward Button: Starts clockwise
spindle rotation.
Downfeed Controls
Identification
A. Fine Downfeed Handwheel
B. Depth Pointer and Scale
C. Quill Lock Lever
D. Depth Pointer Adjustment Knob
E. Downfeed Selector Knob
F. Coarse Downfeed Lever
Using Coarse Downfeed
1. Loosen downfeed selector knob to engage
coarse downfeed levers.
2. Use adjustment knob to adjust depth pointer.
3. Use coarse downfeed levers to lower spindle.
Using Fine Downfeed
1. Tighten downfeed selector knob to engage
fine downfeed handwheel.
2. Use adjustment knob to adjust depth pointer.
3. Rotate fine downfeed handwheel to raise and
lower spindle.
Figure 12. Downfeed controls.
B
C
D
A
F
E