Filter
Top Products
Model G0755 (Mfg. Since 1/13)
-31-
Figure 44. Headstock drain plug
(headstock tilted 90° for clarity).
Drain
Plug
Headstock Reservoir
Oil Type ......Model T23962 or ISO 68 Equivalent
Oil Amount ................................................ 3
1
⁄4 Qt.
Check/Add Frequency ...........8 Hrs. of Operation
Change Frequency ................................ Annually
The headstock has the proper amount of oil when
the sight glass is halfway full (see Figure 42).
Tool Needed Qty
Hex Wrench 8mm .............................................. 1
To change the headstock oil:
1. Run the spindle at 670 RPM for approximate-
ly 10 minutes to warm the oil.
2. DISCONNECT MACHINE FROM POWER!
3. Remove the fill plug (see Figure 43).
Figure 43. Headstock oil fill plug.
4. Place a 1-gallon or larger drain pan on the
table under the headstock.
5. Remove the drain plug (see Figure 44) from
underneath the headstock. Allow the oil to
completely drain into the pan.
Follow federal, state, and local require-
ments for proper disposal of used oil.
6. Replace the drain plug.
7. Add oil until the sight glass is halfway full,
then replace the fill plug.
8. Clean up any spilled oil to prevent slipping
hazards.
Figure 42. Headstock sight glass.
Sight
Glass
Fill
Plug