Filter
Top Products
Model G0755 (Mfg. Since 1/13)
-21-
Headstock
Movement
The headstock travels up and down the column,
and tilts 90° left and right relative to the table.
Raising/Lowering Headstock
Loosen the lock handles shown in Figure 13, then
use the Elevation (Z-Axis) Switch (see Figure 14)
on the control panel to raise/lower the headstock.
Depth Stop
The depth stop limits the downward movement of
the cutting tool. With the use of the depth pointer
adjustment knob (see D in Figure 12), it can be
adjusted anywhere within 0"–5". This is useful
when performing repeat operations.
The limit stops shown in Figure 15 stop head-
stock travel when contacted by the limit block.
The headstock can also be raised/lowered by
hand using the crank shown in Figure 16.
Note: Lock the headstock in place by re-tighten-
ing the lock handles before beginning operation to
avoid unexpected headstock movement.
The Z-axis crank will rotate rapidly and may
cause impact injuries if left attached during
powered Z-axis operation. Always remove
Z-axis crank before using the switch on the
control panel.
Figure 13. Lock handles for headstock elevation.
Lock
Handles
Figure 15. Z-axis limit controls.
Limit
Stops
Limit
Block
Figure 14. Elevation switch that controls
motorized head travel.
Elevation
Switch
Figure 16. Z-axis crank.
Crank