Filter
Top Products
G1023S Series Heavy-Duty 10'' Table Saw -17-
TOOLS REQUIRED: You will need a high quality
square, a long straightedge, 10mm, 12mm,
14mm open end wrenches and a 3mm Allen
®
wrench.
Extension WingsBeginning Assembly
To attach the extension wings to the saw:
1. Attach the left wing to the table using the (3)
3
⁄8"-16 x 1
1
⁄4" Hex Bolts and
3
⁄8" Flat Washers
provided. Adjust the wing reasonably flush
with the table and do not tighten the bolts
completely at this time.
2. Attach the right wing to the table using the
(3)
3
⁄8"-16 x 1
1
⁄4" Hex Bolts and
3
⁄8" Flat
Washers provided. Adjust the wing reason-
ably flush with the table and do not tighten
the bolts completely at this time.
3. Align the top of the wings flush with the table
top directly above the front bolts and flush
with the front edge of the table. Tighten the
front bolts.
4. Raise or lower the rear of the extension
wings until the middle of the wings are flush
with the table top. Tighten the middle bolts.
5. Raise or lower the rear of the wings until the
wings and table are flush. Tighten the rear
bolts.
6. Re-check the flushness of the wings against
the table above each bolt. Re-adjust if nec-
essary.
The table and the wings
represent a very heavy
load. DO NOT over-exert
yourself while lifting or
moving the table and the
wings – get assistance.
Keep clothing rolled up
and out of the way of
machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
!
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.