Filter
Top Products
G1023S Series Heavy-Duty 10'' Table Saw -41-
11. Refer to Figures 40 & 41, for shim place-
ment. If the distance of A is shorter than B,
shim(s) will need to be placed under corners
#1 and #2. If the distance of B is shorter than
A, shim(s) will need to be placed under cor-
ners #3 and #4. Very thin shim stock works
well, just make sure they are all the same
thickness, and you put an equal number
under each of the two corners.
12. Tighten down one bolt a small amount and
then move on to each of the others, tighten-
ing each down the same amount. Continue
to rotate through the bolts, tightening them a
little each time until they are all secure.
13. Now recheck the blade to miter slot at 90°
and 45° by repeating Steps 1-5. If the dis-
tance of A and B are equal, continue to the
“Miter Gauge” instructions. If the distances
are still off, repeat Steps 9-12.
14. Once you feel you have the miter slot adjust-
ed to the blade, recheck all measurements
and be sure the table mounting bolts are
secure. Repeat Step 12 on Page 25. If the
table is removed in the future, be sure to re-
install the shims the same way they came
off.
Figure 40. 45°
blade parallelism measurement.
#1 Shim
45˚ Bevel
#3 Shim
#4 Shim
#2 Shim
!
Figure 41. 45°
blade parallelism measurement.
#1 Shim
#3 Shim
#2 Shim
45˚ Bevel
#4 Shim
!