Filter
Top Products
G1023S Series Heavy-Duty 10'' Table Saw -29-
Crosscutting
To make a 90˚ crosscut using the miter gauge:
1. Adjust the miter gauge to the 90˚ position.
2. Adjust the fence completely away from the
cutting operation.
3. Position the miter gauge in one of the two
miter slots.
4. Adjust the blade height so the highest saw
tooth protrudes approximately
1
⁄4" above the
workpiece.
5. Hold the workpiece against the miter gauge
and line up the cut with the blade.
A crosscut is a cut against the grain direction of
the workpiece. Crosscutting man-made wood
products like plywood is performed by cutting par-
allel to the shortest side.
6. Turn on the saw and allow it to come to full
speed.
7. Hold the workpiece firmly against the face of
the miter gauge and ease it into the blade as
shown in Figure 30.
Figure 30. Typical cross-cut operation.
Keep the blade guard in
the down position at all
times. Failure to do this
could result in serious
personal injury or death.
Turn off the saw and allow the blade to
come to a complete stop before removing
the cut-off piece. Failure to follow this warn-
ing could result in serious personal injury