Filter
Top Products
G1023S Series Heavy-Duty 10'' Table Saw -39-
45˚ & 90˚ Stops
1. Set your blade angle at zero as shown on the
angle indicator on the front of the saw and
raise the blade several inches above the
table.
2. Place a machinist’s square flat on the table
and slide it alongside the blade. The square
should contact the blade evenly from bottom
to top. Make sure that a blade tooth does not
obstruct the movement of the square.
3. Adjust the handwheel until the square is
flush with the blade. Loosen the tilt indicator
arrow, set to zero, and retighten. Loosen and
adjust the stop bolt on the left side of the
front trunnion to allow a 90° stop point. See
Figure 37 for details.
4. Turn the blade angle handwheel until the
angle indicator points at the desired angle.
5. Tighten the handwheel locking knob.
6. Repeat Steps 1-6 for setting the blade to 45°
and adjust the 45° stop bolt on the right side
of the front trunnion. Use the 45° side of a
combo square or a bevel gauge set at 45°.
Figure 37. Geared trunnion.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses
during the entire adjust-
ment process. Failure
to comply may result in
serious personal injury.
45˚ Stop Bolt
90˚ Stop Bolt
SECTION 8: SERVICE ADJUSTMENTS