Grizzly G1023S Saw User Manual


 
-18- G1023S Series Heavy-Duty 10'' Table Saw
Figure 10. Using tape to shim for wing alignment.
Masking Tape
7. Check the alignment of the table and both
wings with a straightedge. The straightedge
should run flat across both wings and the
table top. If the straightedge contacts both
wings and the table evenly, you are finished
with this section. If the straightedge does not
contact them evenly, continue to Step 9.
8. If the extension wings tilt up or down at the
outside edges, remove the wings and shim
them with masking tape as shown in Figure
10.
A) If a wing tilts down, stick layers of mask-
ing tape along the bottom edge of the
table and retighten.
B) If a wing tilts up, stick layers of masking
tape along the top edge of the wing and
retighten. Allow the tape to extend above
table surface and trim the extended tape
with a sharp knife after final assembly.
9. Re-check the alignment of the table and both
wings with a straightedge and re-adjust if
necessary.
Switch
The switch comes prewired to the motor and can
be easily mounted to the rail.
To mount the switch:
1. Line the switch bracket holes up with the
holes on the underside of the rail.
2. Secure the switch and bracket to the under-
side of the rail using the (2)
1
4"-20 x
3
8"Phillip
Head Screws and
1
4
" Lock Washers.
3. Disconnect the machine from the power
source!
4. Connect the plug on the cord between the
switch and motor.
Fence & Rails
Your Model G1023S Series comes with a Shop
Fox
®
Brand Fence & Rails. Refer to the manual
included in the fence box for assembly instruc-
tions.