Filter
Top Products
-34- G1023S Series Heavy-Duty 10'' Table Saw
4. Turn the saw on.
5. When the blade has reached full speed, per-
form a test cut with a scrap piece of wood.
6. If the cut is satisfactory, repeat with your fin-
ish stock.
7. Rotate the workpiece as shown in
Figure 35
.
8. Perform the second cut to complete the rab-
bet cut.
Figure 35. Rabbet cutting.
Always replace the blade guard after dado-
ing is complete. Failure to follow this warn-
ing could result in serious personal injury.
Always use push sticks, featherboards,
push paddles and other safety accessories
whenever possible to increase safety and
control during operations which require the
blade guard and splitter to be removed from
the saw. Failure to follow this warning could
result in serious personal injury.
Never allow hands or arms to be above or
behind the saw blade. Should kickback
occur, the hands and arms can be pulled
into the saw blade. Serious personal injury
could result.
Always turn the saw off and wait until the
blade has come to a complete stop before
adjusting the fence. Failure to follow this
warning could result in serious personal
injury.