Filter
Top Products
-22-
H7761 2" x 27" Belt & 6" Disc Combo Sander
Lubricating Sleeve
Bearings
Lubricate the sleeve bearing with 30 WT oil every
10 hours of operation. No other lubrication is nec
-
essary for this machine.
To lubricate the sleeve bearings:
1. DISCONNECT THE MACHINE FROM THE
POWER SOURCE!
2. Remove the sanding belt.
3. Apply two or three drops of oil in the hole at
the end of the idler pulley (
Figure 15).
4. Wipe of any residual oil.
Note: DO NOT apply extra oil. Too much oil
can cause the belt to slip.
Figure 15. Lubricating the sleeve bearings.