Filter
Top Products
-14-
G1005Z Mill/Drill
Mounting
The Model G1005Z must be mounted to a
workbench or stand before it can be safely used.
If mounting to a stand, follow the mounting
instructions included with the stand. We
recommend using the Grizzly Model G5943
stand, which can be found in SECTION 5:
ACCESSORIES on Page 25.
For workbenches, the strongest mounting option
is a "through mount" where holes are drilled all
the way through the workbench, and hex bolts,
washers, and hex nuts are used to secure the
mill/drill to the workbench.
Figure 5. Example of a through mount setup.
Figure 6. Example of a direct mount setup.
Another option for mounting is a "direct mount"
where the machine is simply secured to the work-
bench with a lag screw.
Assembly
The Model G1005Z must be completely assembled
before it can be safely used.
To assemble the Model G1005Z:
1. Thread the downfeed handle knobs onto the
downfeed handles.
2. Thread the downfeed handles into the pinion
hub, as shown in
Figure 7.
3. Remove the caps from the handwheel hubs.
4. Slide the handwheels onto the handwheel
shafts as shown in
Figure 8, and tighten the
handwheel setscrews.
Figure 8. Table handwheels installed.
Figure 7. Downfeed handles installed.