Filter
Top Products
-30-
G1005Z Mill/Drill
The Model G1005Z comes fitted with a depth
stop to use when drilling multiple holes at the
same depth. The scale on this depth stop can be
calibrated if it ever becomes incorrect.
To calibrate the depth stop
:
1. Loosen the calibration nut shown in Figure
27.
Depth Stop
Calibration
2. Set the depth nut to zero, and secure it with
the jam nut.
3. Tighten the calibration nut to hold the depth
stop in position.
4. Move the depth nut and jam nut to a non-zero
measurement to allow the spindle to move.
5. Test the depth stop by measuring how far the
spindle actually moves from where you set
the depth stop
.
Feed Shaft Spring
Tension
The feed shaft return spring is adjusted at the
factory; however, during the life of the mill/drill
you may want to adjust the feed shaft return
spring so the return pressure suits your operating
needs.
Figure 28. Return spring assembly.
Wear safety glasses when
adjusting springs. Serious
injury may occur if this
warning is ignored!
To adjust the feed shaft spring tension:
1. UNPLUG THE MILL/DRILL!
2. Wipe off any oil on the spring lock cover so
it does not slip in your fingers when you hold
the cover from spinning (see
Figure 28 for
spring lock cover identification
).
Spring Cover
Lock Slot
Spring Lock
Cover
Cap Screw
Figure 27. Depth stop assembly.
Calibration
Nut
Depth Stop
Bracket
Depth Nut
Jam Nut
Return
Height Nut