Filter
Top Products
-16-
G1005Z Mill/Drill
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri
-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
Operation Safety
SECTION 4: OPERATIONS
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC
-
OMMEND that you read books, trade maga
-
zines, or get formal training before begin
-
ning any projects. Regardless of the con
-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
Installing/Removing
Tooling
The Model G1005Z is supplied with both an R8
face mill arbor, for use with the included
2
1
⁄2" face
mill, and a JT6 drill chuck
.
Using Clean Tapers
When installing any tapered tooling, always
ensure
that both tapers (the tooling and the spindle) are
clean and free of grit, oil, dust, and other debris
that could prevent a good fit. Dirty tapers can lead
to poor seating, causing loose (and potentially
dangerous) tooling, or can cause jammed tapers,
making them near impossible to separate.
Figure 9. Attaching a face mill to the mill arbor.
Face Mill
Mill Arbor
3. Secure the tooling in place with the included
cap screw and flat washer.
To install tooling on included mill arbor:
1. UNPLUG THE MILL/DRILL!
2. Seat the tooling on the mill arbor as shown in
Figure 9.
Cap Screw
Flat Washer