Filter
Top Products
-10-
Model T10727 (Mfg. Since 12/12)
Mounting in Vise
The forces exerted on the slip roll during operation
are substantial. The slip roll must be firmly secured
in a vise (see Figure 5 for an example) that is sol-
idly attached to a workbench that will support the
weight and dynamic forces of the operation (refer
to Page 18 for options from Grizzly).
Make sure you have a vise secured to a work-
bench, then mount the slip roll by tightening the
vise jaws against the lug provided at the bottom
of the slip roll.
Note: Use pieces of cardboard, wood, or padded
jaw faces between the vise jaws and the vise lug
to prevent damage to the slip roll.
Make sure the workbench that the slip roll
is mounted on is stable and can support the
weight of the tool, the workpiece, and the
forces exerted during operation.
Assembly
Except for the crank handle and the workpiece
support, the Model T10727 has been assembled
and adjusted at the factory.
To complete the assembly:
1. Thread the handle into the crank arm and
tighten with a screwdriver, as shown in
Figure 3.
2. Attach the workpiece support to the front of
the slip roll with the two pre-installed M6-1 x
12 cap screws, as shown in Figure 4.
Figure 3. Crank handle attached.
Crank
Handle
Figure 4. Workpiece support attached.
Workpiece Support
x 2
Figure 5. Example of Model T10727 secured in
a vise mounted to a workbench.
Slip Roll
Lug