Filter
Top Products
-16-
Model T10727 (Mfg. Since 12/12)
5. Rotate the hand crank clockwise to feed the
workpiece until it is completely through the
rollers, as illustrated in Figure 16.
Workpiece
Figure 16. First bend completed.
Workpiece
Figure 17. Re-inserting workpiece to complete
the cylinder.
Workpiece
Figure 18. Completing the cylinder.
6. Rotate the workpiece 180°, then insert the
curved end back into the slip roll, as illus-
trated in Figure 17.
7. Continue to feed the workpiece through the
rollers until the cylinder is formed, as illus-
trated in Figure 18.
— If the ends of the cylinder do not meet,
equally raise the rear roller at both ends a
small amount, then process the entire cyl-
inder through the slip roll again. Repeat as
necessary.
— If the ends of the cylinder overlap, remove
the cylinder from the upper roller (refer
to Removing Workpiece on Page 17 for
detailed instructions). Then, either attempt
to increase the radius by manually bend-
ing it and reprocessing it, or scrap the
workpiece and start again.
8. Remove the workpiece from the upper roller,
as described in the Removing Workpiece
subsection on Page 17.