Filter
Top Products
-20-
Model T10727 (Mfg. Since 12/12)
Review the troubleshooting and procedures in this section if a problem develops with your machine. If you
need replacement parts or additional help with a procedure, call our Technical Support at (570) 546-9663.
Note: Please gather the serial number and manufacture date of your machine before calling.
SECTION 6: SERVICE
Troubleshooting
Symptom Possible Cause Possible Solution
Slip roll creates
cones when trying
to create cylinders.
1. Rollers are not parallel. 1. Use thickness and radius adjustment knobs to make
sure all rollers are parallel with each other.
A noticeable
crease is formed in
workpiece.
1. Excessive pressure applied in one spot. 1. Raise upper roller to reduce pressure; create form
in multiple light passes.
Hand crank does
not turn upper and
lower rollers.
1. Upper roller too high, gears not meshed.
2. Gears damaged.
1. Use thickness adjustment knobs to lower upper
roller until gears mesh.
2. Replace gears.
Slip roll does not
properly bend
material.
1. Slip roll capacity exceeded.
2. Rear roller not engaged with workpiece.
1. Use material within slip roll forming capacity.
2. Use radius adjustment knobs to engage rear roller
with workpiece.