Filter
Top Products
Model T10727 (Mfg. Since 12/12)
-11-
SECTION 3: OPERATIONS
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Damage to your eyes or hands could result
from using this slip roll without proper pro-
tective gear. Always wear safety glasses and
leather gloves when operating this slip roll.
Basic Controls
Use the descriptions below and Figure 6 below
to become familiar with the basic controls and
components of the slip roll.
Radius
Adjustment
Knob
Workpiece
Support
Hand
Crank
Front
Thickness
Adjustment
Knob
Rear
Roller
Upper
Roller
Lower
Roller
Rear
Figure 6. Model T10727 basic controls and
components.
Thickness Adjustment Knob. Raises and low-
ers the upper roller to adjust for the thickness
of different workpieces. The graduated dial has
0.05mm increments with one full revolution equal-
ing 1.25mm of upper roller movement.
Radius Adjustment Knob. Raises and lowers
the rear roller to create smaller and larger radius
bends.
Hand Crank: Rotates the rollers to feed the
workpiece through the machine.
Sharp edges of sheet metal
can easily cut fingers,
hands, or arms. Always
wear leather gloves when
handling sheet metal, and
always chamfer and debur
the edges.