Filter
Top Products
Model T10727 (Mfg. Since 12/12)
-13-
Creating Bends
The Model T10727 Slip Roll can easily create con-
stant-radius bends in sheet metal up to 20 gauge.
Note: The method for creating a specific radius is
a trial-and-error process. Due to the many varia-
tions among metal workpieces, no single position-
ing will create the same curve on all materials.
We recommend that you experiment with scrap
material before using the actual workpiece until
you find the settings that will achieve your desired
curve.
To create a bend in a workpiece:
1. Use the thickness adjustment knobs to adjust
the height of the upper roller so that you can
place the workpiece between the upper and
lower rollers, as illustrated in Figure 9.
Workpiece
Thickness
Adjustment
Knob
CW
Figure 9. Workpiece positioned for bending.
2. Turn the thickness adjustment knobs clock-
wise to lower the upper roller until the
workpiece is held snug between the rollers.
Be sure to turn the thickness adjust knobs
equal amounts to keep the space and pres-
sure between the rollers even.
3. Turn the hand crank clockwise to feed the
workpiece until its leading edge is just above
the rear roller, as illustrated in Figure 10.
Workpiece
Figure 10. Leading edge of workpiece above
rear roller.
Pinching/Crushing
Hazard
To reduce the risk of inju-
ry, keep hands, fingers, or
other body parts away from
the rollers during opera-
tion.