Filter
Top Products
Page 10SKU 97181 For technical questions, please call 1-800-444-3353.
Mounting Aluminum Disc
Use 10 & 14mm wrenches (not 1.
included) to tighten, if necessary.
(See Figure 1)
Set the Belt/Disc Sander on its feet.2.
Figure 2
Set Screw (6)
3. Slide the Aluminum Disc (5) onto the
Drive Axle (54) so that the Set Screw
Axle (54). (See Figure 2)
Tighten the Set Screw (6) securely. 4.
(See Figure 2)
Mounting Table for use as Disc
Sander
NOTE: The Table (69) may be used as
support for both horizontal and
vertical applications.
Insert end of Table Bar (72) (with 1.
Pivot Indicator) (70) into Bar Holder
(74). (See Figure 3 )
Figure 3
Table Bar (72)
Table (69)
Bar Holder (74)
Pivot
Indicator (70)
Adjusting
Knob (75)
Flat Washer
(26)
Tighten two Set Screws
2. Insert other end of Table Bar (72) into
the Two Mounting supports on bottom
of Table (69). (See Figure 3)
Figure 4
Washer (27)
Pivot
Support (70)
3. Mount the Pivot Indicator (70) tab to
the Table (69) using Hex Bolt (71),