Filter
Top Products
Page 14SKU 97181 For technical questions, please call 1-800-444-3353.
Mounting Sanding Discs
Remove the Table (69), if it is 1.
mounted in front of the sanding disc.
Peel off old sanding disc.2.
Align perimeter of new sanding disc 3.
over the Aluminum Disc (5) and press
NOTE: If you are using the sanding 4.
disc for the rst time. Before
attaching the disc, wipe down the
Aluminum Disc (5) with denatured
alcohol (shellac thinner). This will
clean the surface, leave no residue
and assure a secure bond.
Pressing Magnetic Switch ON will 5.
start the Sander. OFF will stop the
Sander.
When using the Disc Sander, always 6.
disc (as you face it) to sand. The
sanding disc turns counterclockwise
and using the right side could cause
kickback.
Use two hands and hold workpiece 7.
securely at all times.
Always maintain a maximum of 1/16” 8.
clearance between the Table (69) and
sanding disc.
9.
to prevent accidents, turn off and
disconnect its power supply after
use. Remove the Orange Plastic
Key from the Magnetic Switch (31).
Wipe down and store the Sander
indoors out of children’s reach.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the Belt/Disc
Sander. Check for loose screws,
misalignment or binding of moving
parts, cracks and any other condition
that may affect its safe operation.
A Dust Port (59) is located on 2.
the bottom of the Lower Guard
Plate (60). It held in place with
Screw (61) and can be removed
for vacuuming collected dust and
sanding residue. Replace the Dust
WARNING