Harbor Freight Tools 97181 Sander User Manual


 
Page 8SKU 97181 For technical questions, please call 1-800-444-3353.
When using more than one extension 3.
cord to make up the total length,
make sure each cord contains at

(See Table A.)
If you are using one extension cord 4.
for more than one tool, add the
nameplate amperes and use the sum

cord size. (See Table A.)
If you are using an extension cord 5.
outdoors, make sure it is marked with

indicate it is acceptable for outdoor
use.
Make sure the extension cord is 6.
properly wired and in good electrical
condition. Always replace a damaged
extension cord or have it repaired by

Protect the extension cords from 7.
sharp objects, excessive heat, and
damp or wet areas.
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS*
(120/240 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’
50’
75’
100’
150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TABLE A
* Based on limiting the line
voltage drop to ve volts at
150% of the rated amperes.
Symbology
Double Insulated
Canadian Standards Association

V~
Volts Alternating Current
A
Amperes
n
0
xxxx/min.

(RPM)