Filter
Top Products
Page 6SKU 97181 For technical questions, please call 1-800-444-3353.
Specic Safety Rules
Always wear ANSI-approved safety 1.
goggles with full face shield when
operating this Belt/Disc Sander.
Support workpiece with Miter Gage, 2.
Backstop or work table.
Maintain 1/16” maximum clearance 3.
between table and sanding belt, or
disc.
Avoid kickback by sanding in 4.
accordance with the directional
arrows.
Maintain labels and nameplates on 5.
the tool. These carry important safety
information. If unreadable or missing,
contact Harbor Freight Tools for a
replacement.
Avoid unintentional starting. Prepare 6.
to begin work before turning on the
tool.
Do not leave the Belt/Disc Sander 7.
unattended when it is plugged into
an electrical outlet. Turn off the tool,
and unplug it from its electrical outlet
before leaving.
This product is not a toy. Keep it out 8.
of reach of children.
People with pacemakers should 9.
consult their physician(s) before
proximity to heart pacemaker could
cause pacemaker interference or
pacemaker failure. In addition,
people with pacemakers should:
on.
avoid electrical shock.
grounded. Ground Fault Circuit
Interrupter (GFCI) should also be
implemented – it prevents sustained
electrical shock.
Some dust created by power 10.
sanding, sawing, grinding, drilling,
and other construction activities,
contains chemicals known [to the
State of California] to cause cancer,
birth defects or other reproductive
harm. Some examples of these
chemicals are:
cement or other masonry products
chemically treated lumber
Your risk from these exposures
varies, depending on how often you
do this type of work. To reduce your
exposure to these chemicals: work in
a well ventilated area, and work with
those dust masks that are specially
particles. (California Health & Safety
Code § 25249.5, et seq.)
The warnings, precautions, 11.
and instructions discussed in
this instruction manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
S A V E T H E S E
INSTRUCTIONS.