Filter
Top Products
Page 11SKU 97181 For technical questions, please call 1-800-444-3353.
(27). (See Figure 3 & 4)
Mount Pivot Indicator (70) to the Bar 4.
Holder (74) using the Adjusting Knob
tighten. (See Figure 3 )
Tighten all fasteners. Make sure 5.
Pivot Indicator operates smoothly
when Angle Adjustment Knob (75) is
loosened.
Figure 5
Support Shaft (76)
Bar Holder
(74)
6. Slide Support Shaft (76) into Bar
shaft with set screws and tighten
securely. Slide Support Shaft
(76) into existing hole on side of
Machine Body (33) and with wrench
(not supplied), tighten Bolt (32).
(See Figure 5 )
Mounting Table for use as Belt
Sander
NOTE: The Table (69) may be used
for both horizontal and vertical
operations.
Remove Table from Machine Body 1.
using reverse procedures in number
6 of “Disc Sander” section above.
Figure 6
Support
Rod (23)
Outer Pulley Cover (9)
Disc Cover (8)
Nut (22)
2. Set Belt/Disc Sander in vertical
position by loosening both Nuts (22).
Raise the Belt Support Housing (52).
When it is vertical, tighten both Nuts
(22) very tight to prevent the Belt
Support Housing (52) from slipping.
(See Figures 6 & 7)