Filter
Top Products
Page 12SKU 97181 For technical questions, please call 1-800-444-3353.
Figure 7
Belt Adjustment Knob (49)
Table (69)
Sanding
Belt
Belt
Tighten
Handle
Sanding
Disc
Magnetic Switch (31) with
Orange Safety Key inserted
Miter
Gauge
(65)
3. Insert Support Shaft (76) into the hole
facing the belts and tighten Bolt (32)
(76). (See Figures 6 & 7)
Mounting Stop Plate
1.
top of the sanding belt and is for
preventing workpiece from moving to
the rear when sanding.
Align the two Tabs on the Stop Plate 2.
(63) with the two Holes on the top of
the Band Support Housing (52). The
Tabs will be underneath the Flange
on the Band Support Housing (52).
Insert two Machine Screws into the
two Holes and thread them into the
Tabs on the Stop Plate (63). Note:
head and upper Guard Plate (58).
(See Figure 6)
Figure 8
Belt
Adjustment
Knob (49)
Stop Plate (63) (Tabs (not shown) are
underneath Flange on Band Support
Housing (52) where Machine Screws
are shown).
Machine Screws
Band
Support
Housing (52)
3. Mount the Stop Plate (63) to the
Band Support Housing (52) using
Washer (27). (See Figure 8)