Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 98871
SAFETY SERVICEBASIC WELDING WELDING TIPSSETUP
Wire Spool (27) Installation
1. Turn the welder OFF and unplug it
before proceeding.
2. Press in the Cover Latch (8) on the front
of the handle, then open the Cover (31).
3. Remove the Wing Nut (25) and the Spool
Retaining Nut (26). If replacing a Spool,
remove the old Spool and all remaining
wire from the liners.
Make sure the Spool Spring (24) is in 4.
place on the Spool Spindle (28).
Place the new Wire Spool over
the Spool Spindle (28) and on top of the
Spool Spring (24) as illustrated.
To prevent wire feed problems,
set the Spool so that it will unwind
counterclockwise.
Secure Spool in place with the Spool 5.
Retaining Nut (26), then the Wing Nut
(25).
90 AMP FLUX WIRE WELDER
120 V~
60 Hz
Gun
WIRE-FEED SPEED
0
1
2
3
4
5
6
7
8
9
10
MAX
MIN
ON
OFF
Wire
Spool
(27)
Cover
Latch (8)
Cover (31)
Wing Nut (25)
Spool Retaining Nut (26)
Wire Spool (27)
Spool Spring (24)
Spool Spindle (28)
wire must
unwind this
direction