Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 98871
SAFETYSERVICE BASIC WELDINGWELDING TIPS SETUP
Face Shield (38) Assembly
Attach the handle to the Face Shield (38)
by lining up the two rectangular tabs on
the handle with the corresponding holes in
the face shield and
press the tabs through the holes and A.
then
slide the tabs forward from the back, B.
locking the round tab in place.
Cover (31) Assembly
1. Slide the Handle (30) into the slot on the
Cover (31) from the front.
The notch on the back of the Handle
should drop into the slot in the Cover.
BothendsoftheHandleshouldlayush
against the top of the Cover.
Then, secure using Screw (29) as shown.
2. Attach the Cover Latch (8) to the front of
theBaseFrame(14)usingtheBolt(42),
Washer (40), Lock Washer (50) and Nut
(41) as shown.
Handle
Face
Shield
(viewed from front)
AA
BB
Round
Tab
Handle (30)
notch drops
into slot on
Cover here
Screw
(29)
Cover
(31)
Cover
Latch (8)
Bolt
(42)
Washer
(40)
Nut
(41)
Lock
Washer (50)
SETUP
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning
of this manual including all text under subheadings therein before set up or use
of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch off and unplug the welder before assembly.