Filter
Top Products
2-9
Turning Power On/Off
To turn the terminal On, press the Power button .
To turn the terminal Off:
1. Press and hold the Power button for approximately 4 seconds until the options menu displays.
2. Tap Power off.
Suspend Mode
Suspend mode differs from Power off mode. Power off mode is the equivalent to having no battery or
external power source connected to the device. In Suspend mode, the device enters a low power state
to conserve battery power.
Suspend mode automatically turns the system off, which includes turning the screen off to save battery
power when the terminal is inactive for a programmed period of time. The automatic timeout limits are
adjustable from the Advance tab located under Settings > System > Power (see page 7-14). In
addition, Suspend mode also automatically turns off the radio and drivers. The PMIC and main
processor wakeup mode clock remain on allowing the system to detect a wakeup interrupt and to
resume working.
Press and release the Power button to toggle the terminal in or out of Suspend mode.
Note: You should always place the terminal in Suspend mode before removing the battery.
Resetting the Terminal
There are three types of system resets: a Soft Reset,aHard Reset,oraFactory Reset. The soft and
hard resets preserve all data stored in the file system. Contact a Honeywell technical support represen-
tative for more information on how to perform a Factory Reset. For contact information, see Technical
Assistance on page 14-1.
A Soft Reset (Warm Boot) re-boots the device and preserves any objects created in RAM. You would
perform a soft reset when: the terminal fails to respond, after installing some software applications, or
after making changes to certain system settings, such as network cards.
A Hard Reset (Cold Boot) re-boots the terminal and closes any open applications running in RAM at the
time of the reset.
To perform a Soft Reset or Hard Reset:
1. Press and hold the Power button until the options menu appears.
2. Tap Soft Reset or Hard Reset on the menu.
3. When the reset is complete, the Home screen displays.
Note: To perform a Hard Reset if the screen has stopped responding, press and hold the Power button for
approximately 8 seconds until the terminal starts to re-boot. When the reset is complete, the Home screen
displays.