Filter
Top Products
3-8
The battery must be charged to full capacity before using the Dolphin 6110 for the first time!
Charge the battery pack with the Dolphin USB Charging/Communication cable until the LED turns green
(red while charging). The average charge time for a fully depleted battery is 7 1/2 hours. It takes less
time if the battery has some charge.
Battery Pack
Caution: We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result
in damage not covered by the warranty.
There are two Li-ion battery packs available for the 6110:
Standard Capacity: Li-ion 3.7V/2200mAh/8.1Wh
Extended Capacity: Li-ion 3.7V/3300mAh/12.2Wh
Changing the Battery Pack
Before installing a battery pack, press the Power button to put the terminal into Suspend Mode (see page
2-9) so that operations are suspended before removing the power source. The Dolphin 6110 is shipped
with the battery separate from the unit. You will need to loosen the hand strap, remove the battery door,
insert the battery, and replace the battery door. Refer to the instructions included in "Install the Battery" on
page 2-1 section.
Note: The battery door must be installed prior to booting the unit.
Charging Options
Dolphin terminals ship with the battery significantly discharged of power. Before using a Dolphin terminal
for the first time, charge the battery with a Dolphin charging device for a minimum of 6 hours for the
standard battery and 9 hours for the extended battery. When the battery is installed in the terminal, you
can use any of the peripherals listed below to charge the battery.
• Dolphin HomeBase (Model 6100-HB)/eBase (Model 6100-EHB) Device (see page 10-1)
• Dolphin Comm/Charge Cable; Managing Battery Power (see page 3-9). You may charge the device
using the USB connection if you do not have a wall adapter. Access the option by selecting >
Settings > System > Power > USB Charging (see see Charging Terminal with USB Cable on page
8-1).
To fully charge the Li-Ion battery before installing it in the terminal, use the
• QuadCharger Device (see page 13-1) or insert the battery in the spare battery charging well in the back
of either the Dolphin HomeBase or Dolphin eBase.
!
Cover Locks
Battery