Filter
Top Products
3-7
Bottom Panel Features
DC Power Jack
The DC power jack receives external power from the Dolphin power cable that is included in
the box with the terminal. When connected to the Dolphin power cable, the terminal is powered
and the battery pack is charging.
I/O Connector
The I/O mechanical connector is designed to work exclusively with Dolphin 6110 peripherals
and cables. This connector powers the terminal, charges the battery, and facilitates
communication. The I/O connector supports High-speed USB 2.0 communication (up to 480
Mbps) and RS-232 communications with a maximum speed of 115Kbps and seven baud rate
settings.
Through this connector, you can communicate with a host workstation via Microsoft
ActiveSync; see Connecting and Synchronizing the Terminal and Workstation on page 8-9.
The I/O connector supports the following signals:
•DCIN
• Transmitted Data
• Request To Send
• USB Host +5V
• USB Host D+
• USB Host D-
• USB Host Detect
• Clear To Send
• Received Data
• GND
• RS-232 Shutdown
• USB Client D+
• USB Client D-
• USB Client +5V
Note: Signals referenced are for a DTE device.
Battery Power
The battery pack is located on the back panel (see Battery Pack on page 3-8)
DC Power Jack
I/O Connector