Filter
Top Products
7
Unpacking
Remove all crating and plastic from around the
Mortiser. Check for shipping damage; report any
damage immediately to your distributor and
shipping agent. Do not discard any shipping
material until the Mortiser is assembled and
running properly.
Open the cabinet rear door and remove any
boxes and accessory items. Compare these with
the following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
1 Mortiser
1 Handle
1 Chisel and Auger set – 3/4”
1 Chisel and Auger set - 1”
3 Bushings - 5/8”, 3/4” and 1-1/8” I.D.
(NOTE: The 5/8” bushing is already installed
on the mortiser)
3 Combination Wrenches: 12-14, 17-19, 22-24
4 Hex (Allen) Wrenches: 3, 4, 5 and 6mm
1 Chuck Key
1 Chuck Extension Adaptor
1 Wood Table
2 Phillips Flat Head Screws, M6 x 20L
1 Reversible (Cross Point/Flat Head)
Screwdriver
1 Owner's Manual
1 Warranty Card
Read and understand the entire contents of this manual before attempting set-up
or operation! Failure to comply may cause serious injury.